Additional Information

Site Information

 Loading... Please wait...

1995

1.  Locate the red two wired programming connector located near the central
     locking control module. behind LH Lower instrument panel

2.   Inside the Red programming connector you will see to pins..
      Jump two pins with a section of wire.

3.  System should now lock and unlock doors to indicate vehicle has entered
     programming mode.

4.  Press any button on keyless remote once. System should now lock and unlcok
     doors indicating the keyless remote has been programmed.

5.  Repeat step 4 to program other remote.

6.  Remove jumper wire from programming connector to exit programming mode.

7.  Test Remote(s)

    There are no products in this category.